Labelers

Manuals and Parts

Manuals and Parts for MEP Labelers


MEP Labeler on Cart (cart is an option)

MEP SemiAutomatic Labeler $4695 in stock
Professional semiautomatic labeler for cylindrical bottles. Easy to set up and operate. Uses a photocell and timer for very easy adjustment to center the back label. It can also apply a single label that wraps the entire bottle.
Labeler must be crated and shipped LTL.

Optional Cart $475 in stock
Stainless steel with 4 wheels. 20" height for ergonomic use. Labeler bolts to stand.

  • Semi-automatic table top machine for self-adhesive labels
  • Applies both front and back labels (labels must be on same roll)
  • Front Label width maximum is the circumference of the bottle (i.e., you can use a single label that wraps the entire bottle)
  • Cylindrical bottles, diameter 2.36" to 4.4" (will not apply labels to tapered bottles)
  • 600 bottles/hour. 3.5 seconds per cycle.
  • Easy to operate and maintain
  • 110 V
  • Bottle is vertical during labeling
  • Core size 3"
  • Max roll diameter 8"
  • Label height max 6"
  • Dimensions: 165 lbs. 34"x19"x24" (LxDxH). Height on optional cart is 44".
  • Label Orientation. You must have #4 in this pdf. The orientation is easily seen in the photo above.
  • Other specs are included in the manual.
  • Maximum length from the bottom of the bottle to the bottom edge of the lowest label (front or back) is 2-1/8"
  • The circumference of the bottle must be a minimum of 1" longer than the total length of the front and back labels.

Movie of Labeler. Movie shows ease of changing the spacing of back label. After the first bottle, the 2nd label delay is changed.

Clear labels on clear backing. The labeler works fine with virtually all labels. However, it will not work with clear labels on clear backing. It will work with clear labels on white (or any color) backing.

MEP Labeler—Square and Cylindrical bottles $6350 in stock
Same as standard unit at left but includes accessory for labeling square bottles. Very simple to switch between square and cylindrical bottles. In addition to specs at left, square bottles with 65-75 mm sides. Can be modified to label square bottles of different size---please send specs or bottle.

Application of front and back labels on square bottles. Apply front label, then turn bottle and apply back label. The front and back labels must be the same width and on the same roll. If you wish to apply front and back labels of different widths, then the front and back labels must be on different rolls. Label all bottles with front label, change labels and then apply back labels.

Horizontal vs Vertical Labeling
Wine bottles should be kept upright after corking for up to two hours to protect against leakage. It takes time for the cork to fully expand and seal. Vertical labelers can be used immediately after corking while horizontal labeling should be delayed up to two hours.